Actions

Honda VFR750F RC36

From GummyCarbs

1994 - 1997 Honda VFR 750.

Consumables

Brake Pads

EBC

  • Front Semi-Metalic FA142 (organic?) (two sets required)
  • Front Metallic FA142HH (sintered?) (two sets required)
  • Rear Semi-Metallic FA196 (organic?)
  • Rear Metallic FA196HH (sintered?)

Spark Plugs

NGK

According to the NGK parts-finder, these are the spark plugs for the 1990 - 1997 VFR750F:

  • Standard: p/n CR9EH-9, stock no. 7502, gap 0.035"
  • Iridium: p/n CR9EHIX-9, stock no. 6216, gap 0.035" ($7.32 from Amazon)

Accessories

Windscreens

Zero Gravity

MRA

  • ???

Givi

  • ???

Comparisons

  • This page indicates that the Givi is loud, possibly due to turbulence kicked up by the 'Euro flip'.

Electrical

Regulator/Rectifier

The regulator/rectifier on the VFR is a common point of failure. Usually, by 20k miles, it will have given out.

Rick's Motorsport Electrics

Part # Description MSRP
10-115 OEM Style Rectifier-Regulators $120.00
21-117 New Stator $140.00
60-144 Rebuilt Starter Motor $155.00

Honda

Honda has replaced the old regulator/rectifier with a redesigned model which has more substantial cooling fins.

OEM

The stock unit appears to be made by Shindengen. Their generic regulator rectifier can be purchased at their online store.

GSXR

GSXR regulator/rectifiers can be adapted. They appear to be much more substantial than the VFR units. They seem to all use pigtails, which makes it easier to adapt for use with a VFR.

This post describes how to wire a "five-wire" GSXR regulator/rectifier to a Honda Superhawk:

The three yellow honda wires go to the the three gsxr black wires. It doesn't matter which goes to which just that the three yellows go to the three black. The honda red wire goes to the gsxr black with red stripe wire and the honda green wire goes to the gsxr black with white stripe wire.

This post also discusses a 5-wire GSXR unit.

3 black gixxer to 3 yellow honda

black/white gixxer to green honda

black/red gixxer to red honda

R1 or YZF

R1 regulators appear to have massive cooling fins. However, they use a plug mounted directly to the body of the regulator, much like the standard Honda unit, which may make it more difficult to adapt for use on a VFR.

  • A page on using R1 regulators on VFRs.

This post explains the single-connector R1 pinout:

The Yamaha's male spades are arranged like this:

- - -
 - -

The three spades at the top are the 3 phases of AC power coming from the stator (the yellow wires). They're interchangable. The bottom two are the (+) and ground. I can look at my VFR tonight and tell you which is which.

A follow-up says that the ground is on the 'left' in the above pinout.

Resources