Actions

Charging System: Difference between revisions

From GummyCarbs

Jeff (talk | contribs)
Jeff (talk | contribs)
Line 6: Line 6:


[http://forum.svrider.com/showpost.php?p=1326017&postcount=3 This post] says the  Shindengen <s>FH012AA</s> FH020AA is now the best is the best regulator/rectifier in use today.  It's rated at 50A output, and runs cooler than shunt-type regulators.  It's used on:
[http://forum.svrider.com/showpost.php?p=1326017&postcount=3 This post] says the  Shindengen <s>FH012AA</s> FH020AA is now the best is the best regulator/rectifier in use today.  It's rated at 50A output, and runs cooler than shunt-type regulators.  It's used on:
* 2006+ Yamaha FJR
* <s>2007+ Yamaha FJR</s> (older -12 model)
* 2006+ Yamaha R1
* <s>2006+ Yamaha R1</s> (older -12 model)


[http://forum.svrider.com/showthread.php?p=1425812 This thread] discusses sourcing the MOSFET-based FH008 and FH012 regulator/rectifiers from CBR600RR and CBR1000's.
[http://forum.svrider.com/showthread.php?p=1425812 This thread] discusses sourcing the MOSFET-based FH008 and FH012 regulator/rectifiers from CBR600RR and CBR1000's.
Line 16: Line 16:
* FH011AA - has enormous fins, avoid it ([http://forum.svrider.com/showpost.php?p=1356901&postcount=6 shown as on a 2004-2006 Yamaha R1])
* FH011AA - has enormous fins, avoid it ([http://forum.svrider.com/showpost.php?p=1356901&postcount=6 shown as on a 2004-2006 Yamaha R1])
* FH012 - 50 amp, Yamaha p/n 1D7-81960-00-00
* FH012 - 50 amp, Yamaha p/n 1D7-81960-00-00
* FH022BA found on 2017 R1


* FH020AA 50 amps peak, 35 amps continuous ([https://www.vmaxforum.net/threads/regulator-rectifier-shindinguen-fh001-vs-electrosport-esr279.47773/ source])
* FH020AA 50 amps peak, 35 amps continuous ([https://www.vmaxforum.net/threads/regulator-rectifier-shindinguen-fh001-vs-electrosport-esr279.47773/ source])

Revision as of 05:58, 21 April 2020

Modifications

MOSFET Regulator/Rectifiers

Update: The FH020AA is now the best mosfet unit.

This post says the Shindengen FH012AA FH020AA is now the best is the best regulator/rectifier in use today. It's rated at 50A output, and runs cooler than shunt-type regulators. It's used on:

  • 2007+ Yamaha FJR (older -12 model)
  • 2006+ Yamaha R1 (older -12 model)

This thread discusses sourcing the MOSFET-based FH008 and FH012 regulator/rectifiers from CBR600RR and CBR1000's.

  • Part numbers beginning with F designate MOSFET-based models. Part numbers beginning with 'S' indicate shunt/SCR models.
  • FH020AA 50 amps peak, 35 amps continuous (source)

FH020AA vs FH012AA - FH020AA is the latest and greatest (source)

Electrosport

Electrosport sells stators which claim to increase power output over stock. Increased wattage at high RPMs is gained at the expense of wattage at lower RPMs. If a bike is to be ridden around town regularly, the stock stator may be preferred. An image was posted by an Electrosport employee to this thread which shows the output trade off of their KLR650 stators:


Electrosport Warning

There appear to be several accounts of Electrosport products failing due to what appears to be poor construction.

Personally, I put an Electrosport regulator/rectifier on my VFR-750 and it was terrible. The charging level fluctuated badly (my headlight would become noticeably brighter, then dimmer) and it failed completely after six months.

Regulators

This post on VFRDiscussions.com recommends Yamaha R1 regulators from 2004 and later:

"lots of folks with R1's from around 03 and earlier had RR problems, but the 04's and up the problem was corrected."

02 - 03 R1 Regulator/Rectifiers appear to be FH001 (Same as '04 - '07 FJR1300)